top of page

Ergo 2 Chair

Take a seat on the chair and run through the below adjustments in order to set the chair up.

*May not be on your model. Options marked with a * are additional extras.

Image of seat height adjustment lever on the Ergo 2 chair

Seat Height

To adjust the height of the chair, raise the lever "HEIGHT" and remove weight from the chair, this will then raise. To lower, apply weight to the chair and raise the lever again. This will lower the chair. 

Image showing the Ergo 2 chair with additions of headrest and adjustable armrests

Back Height

The back height is adjustable on a ratchet mechanism. Grab the backrest with 2 hands and raise it. The back will start to raise click by click. Once it reaches the top of the ratchet, it will drop down again. 

Close up of the armrest option on the Ergo 2 chair

Height Adjustable Armrests*

To alter the height of the armrest, lift the armrest top and it will raise click, by click. Once the arm reaches the highest position, it will drop to the lowest and start the ratchet again.

Image showing the seat angle adjustment and back angle adjustment levers on the Ergo 2 chair

Seat Angle

Raise the lever "SEAT" to alter the seat angle by pushing back into the chair. This will allow the seat and back to move.

Image showing the seat angle adjustment and back angle adjustment levers on the Ergo 2 chair

Back Angle

Alter the backrest angle with the lever "BACK". Raise the lever up and this will allow you to change the angle. 

Image of the 3D adjustable armrest on the Ergo 2 Chair

3D Armrests*

Raise the height of the armrest using the button on the outside of the armrest. You are also able to alter the width and depth of the arm using the small button on the side of the armrest top.

Image showing the seat depth adjustment lever on the Ergo 2 Chair

Seat Depth*

Raise the lever to lengthen or shorten the seat pad. When sitting you should have a small gap of 2-3 fingers from the front of the seat to the back of your knee. 

*This can be easier to adjust when off the chair

Image of the inflatable lumbar bulb on the Ergo 2 chair

Inflatable Lumbar*

Squeeze the lumbar bulb to inflate air into the lower portion of the backrest. Deflate this, by pushing the button at the top of the lumbar bulb. 

Headrest shown on the Ergo 2 chair

Headrest*

To alter the height of the headrest, simply pull it up out of the backrest, or push it down. You are also able to alter the angle by manipulating it with your hangs.

Ergo 2 Chair

The Ergo 2 chair comes with the following adjustments as standard:

- Seat height adjustment

- Seat angle adjustment

- Back height adjustment

- Back angle adjustment

Additional extras:

- Inflatable lumbar support

- Seat depth adjustment

- Height adjustable armrests

- 3D armrests

- Headrest

bottom of page